12 Section 4 — ASSembly & inStAllAtion
Figure 4-15
5. If not already flipped forward, flip seat forward to allow for
the grass bags and upper tube assembly steps.
6. Open bagger cover by pushing in on the rear, right-side
tab with your right hand, as shown in (1) of Figure 4-16, and
lifting the cover with your left hand in the center rear of the
bagger cover, (2).
Figure 4-16
3. Install the grass catcher cover onto the bag support
assembly, as shown in Figure 4-13. The grass catcher cover
goes inside of the two mounting tabs on the bag support
assembly.
Figure 4-13
4. Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-14. Use the cut-out window (See inset in
Figure 4-14) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-15.
Figure 4-14
To Next Page
Loading...
