Steering and Front Axle
11
Right Front Axle Removal
1. Raise the tractor and support it with a jack stand.
2. Remove the wheel and tire as described above.
3. Remove the cotter pin that fastens the fixed tie rod to
the axle.
See Figure 3.5.
4. Loosen the clamp bolt that secures the steering arm
to the square-section at the top of the axle using a
pair of 1/2” wrenches, and lifting the arm off.
NOTE: Note the spacer below the steering arm. Slide the
axle from.pivot bar.
Removing the axle allows access to the upper and
lower flange bearing and side axle cap. Inspect these
components for wear or damage and replace if necessary.
See Figure 3.6.
Assemble in reverse order of disassembly.
General Information
Continued operation with worn bearings will cause rapid
tire wear. If the bushing wears through completely, the
pivot bar will be damaged.
Replace any single-use fasteners (push-on caps and
cotter pins) with new ones on reassembly.
Lubricate all friction surfaces with grease such as MTD
P/N 737-0300A upon reassembly.
Tighten the steering arm clamp bolt to a torque of 200-
260 in-lb. (22.6 Nm-29.4 Nm). Replace the nylon ring lock
nut if it has lost its retaining capabilities.
Pivot Bar
Pivot bars are not normally replaced in the service life of a tractor. The most common reasons for replacing a
pivot bar are:
• Damage caused by dropping the tractor (e.g. while loading or unloading from a truck), or collision with an
object.
• Damage caused by continued use after the axle bushings have deteriorated.
NOTE: Various hood and engine combinations may require using slightly different procedures than listed
below. The most common deviations will be on the muffler and muffler guard removal and the hood
pivot bracket removal. These instructions demonstrate removal of a stamped steel pivot used on most
riders. Procedures for replacing cast iron pivot bars are similar.
Figure 3.5
Cotter Pin
Steering Arm
Clamp Bolt
Spacer
Figure 3.6
Flange Bearing
Side Axle Cap
Flange Bearing
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
