Cutting Decks
169
Deck lift links
The deck lift links have two functions. The first function is to support the rear of the deck. The second function is
to raise or lower the deck in response to movement of the deck lift lever.
To accomplish the second function, the deck lift rods connect from the deck lift shaft assembly to the deck lift
links.
The deck lift links have several holes that are used to support different cutting decks. Note the position of the lift
rods and links where they attach to the deck during disassembly.
Manual PTO Blade Engagement Lever
The Manual PTO handle engages the cutting blades
with a spring tensioned cable that runs from the handle
assembly on the right fender to the cutting deck.
In the disengaged position the lever presses down on
the reverse safety switch. An extension spring maintains
pressure on the switch in this position. See Figure 8.39.
A two-piece plastic bearing supports the lever where it
passes through the frame. See Figure 8.40.
Figure 8.39
Tension spring
Reverse safety switch
Deck engagement cable
Figure 8.40
Two-piece plastic bearing
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
