Body Panels
25
Hood components
Headlight bezels, grills, pivot brackets and other parts
attach to the hood using screw fasteners. The many variet-
ies of hood styles does not allow a thorough description of
procedures in this service manual. Refer to the illustrated
parts list for your particular rider for reference. In many
cases part numbers are imprinted on plastic parts to aid in
identification. See Figure 4.5.
Seat and Fenders
There are four variants of fender used on the Cub Cadet Series 1000 for the model year 2009 and after:
• Manual PTO models have two levers on the right fender: one for the deck height control and one for the
PTO.
• Electric PTO models have one lever on the right fender to control the deck height.
• CVT-drive tractors (single-speed transmission + variable speed pulleys) use fenders with a single pedal
opening on each side: clutch/brake on the left, drive pedal on the right. In addition, a forward-neutral-
reverse lever is on the left fender.
• Hydrostatic-drive tractors use fenders with a single pedal opening on the left, and two openings on the
right. The clutch/brake pedal is on the left, with two pedals on the right; one to control forward drive, and
the other to control reverse drive.
NOTE: Removing the fenders offers easier access to:
• Parts of the drive system
• Deck engagement and deck lift components.
• Drive tensioner pivot bracket bolt (some models).
Figure 4.5
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
