Body Panels
31
Dash Panel
The dash panel will typically only need to be removed if it is damaged. The dash assembly has a lower portion
made of painted steel and a upper portion made of plastic. The upper portion is molded to accommodate the many
different hood designs used on the 700 series riders. The steel portion comes in several styles, some designed to
accommodate the RMC (mow in reverse) module and some without. You can replace the upper portion of the dash
without removing the lower portion.
To remove the upper dash:
1. Open the hood.
2. Remove the two hex screws under the dash securing
the upper dash to the lower dash.
See Figure 4.16.
3. Remove the two hex screws (one on each side)
securing the sides of the upper dash panel to the
lower dash panel.
See Figure 4.17.
4. Remove the upper dash.
5. Install in the revers order of disassembly.
Figure 4.16
Upper dash screws
Figure 4.17
Dash panel screw
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
