700 Series Lawn Tractor
46
Drive pedal and brake pedal shaft assembly removal
NOTE: The entire pedal rod assembly can be
removed, or just the side being worked on.
These instructions show how to remove the
entire rod assembly.
NOTE: Confirm that the parking brake is released
before starting work.
1. Remove the mowing deck.
2. Disconnect the rod that joins the arm at the left side
of the brake/clutch shaft to the drive belt tensioner
pulley bracket.
See Figure 5.22.
2a. Remove and set aside the hairpin clip.
2b. Remove the rod from the pedal shaft bracket.
3. Remove the clutch/brake pedal return spring.
See Figure 5.23.
NOTE: Note the location where the spring attaches
to the brake pedal bracket and the frame.
4. Remove and discard the cotter pin that holds the
double idler pulley control rod to the “cobra head”
arm on the drive control pedal.
See Figure 5.24.
5. Remove the rod from the bracket.
Figure 5.22
Remove hair pin clip and rod from bracket
Figure 5.23
Clutch/brake pedal return spring
Figure 5.24
Cotter pin
Control rod
Cobra head
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
