Hydrostatic Transaxles
79
Cross-shaft and control lever
1. Remove the handle from the lever using a blow-gun.
See Figure 6.11.
2. Lift and safely support the back of the tractor.
3. Remove the rear wheels using a 1/2” wrench.
4. Disconnect the rod from the bell crank to the input
arm.
5. Remove the bushings or unbolt the brackets from the
frame.
6. The control lever and cross shaft assembly can then
be maneuvered out from under the fender.
See Figure 6.12.
7. The cross shaft, control lever, and torsion spring can
be disassembled on the bench.
See Figure 6.13.
Figure 6.11
Figure 6.12
Figure 6.13
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
