Discharge Chute and Controls (Electric)
129
13. Insert the Pinion Gear so that the travel stop is 3/4”
from the edge of the bracket.
NOTE: Lubricate all friction surfaces with Renolit Polar
Grease part number 937-04085.
14. Set the housing on top of the Gear Set. Install the five
screws using a 5/16” wrench.Tighten the screws to a
torque of 20 - 30 in lbs (2 - 3 Nm). See Figure 11.28.
15. Install the Remote Head on the chute by following the
procedures described in the Discharge Chute Sec-
tion of this chapter.
16. Test run the unit in a safe area before returning it to
service.
To Next Page
Loading...
