600 Series Drive System
35
Friction Wheel Replacement
1. Remove the drive shaft by following the procedures
described in the Hex Drive Shaft Assembly section of
this chapter.
2. Remove the bearing from one end of the shaft.
3. Slide the Friction Wheel Assembly off of the shaft.
NOTE: On the single speed models, drive out the roll pin
holding the friction wheel to the hex shaft.
4. Remove the four screws that hold the Friction Wheel
Assembly together using a 1/2” wrench.
NOTE: Earlier production units require 3/8” wrench for the
four screws.
5. Separate the Friction Wheel Assembly. See Figure
4.11.
To Next Page
Loading...
