700 Series 3-Wheel Track-Drive System
61
6. Remove the bearing and washers.
NOTE: Keep track of the order of the washers for reas-
sembly. See Figure 6.22.
7. Carefully remove the E-ring that secures the Plane-
tary Set. See Figure 6.23.
8. Slide the Planetary Gears Set off of the Hex Drive
Shaft.
9. Remove the washer that was behind the Gear Set.
NOTE: The washer behind the Gear Set is the thinnest of
the three washers. See Figure 6.24.
10. Slide the Friction Wheel Assembly off of the Hex
Drive Shaft.
11. Repeat steps 6 through 9 on the opposite side of the
Hex Drive Shaft.
Figure 6.22
Bearing
Thick Washer
Thin Washer
Figure 6.24
Thinest washer
To Next Page
Loading...
