MTD 700 Series - Page 84

Medium Frame 2 & 3 Stage Snow Throwers
80
14. Drive out the front bearing.Figure 7.37.
15. Remove the seal.
16. Clean and dry all components.
17. Inspect the components.
NOTE: If there are signs of wear or damage,
replace the affected component(s).
18. Install the front bearing, using a brass punch to seat
it. See Figure 7.38.
NOTE: The front Bearing Pocket does not have a
snap ring grove, the rear does.
19. Install the right bearing, using a brass punch to seat
it. See Figure 7.39.
NOTE: The left Bearing Pocket has a snap ring
grove, the right does not.
Figure 7.37
Figure 7.38
Figure 7.39