To Next Page

To Previous Page

MTX.COM

Step 10 - Reconnect the speaker to the speaker wires and mount the speaker to the pod using a T15

Torx driver and the screws removed in Step 4.

Note: These screws use the threaded brass inserts and not the pre-drilled holes

Step 11 - Install the speaker grills using a the supplied Phillips head screws and a Phillips

screwdriver or screw gun

Step 12 - Once secure, make your speaker wire connections and reassemble the top dash panel

securing it in place with the hardware removed in previously.

Questions and Answers:

Need help?

Do you have a question about the MTX RNGRPOD65 and is the answer not in the manual?

MTX RNGRPOD65 Specifications

General