MTX TXC6.1 - BI-AMP CONFIGURATION

BI-AMP
CONFIGURATION
These
crossovers
feature
Bi-amp
connections
so
that
the
components
can
be
wired
to
drive
the
tweeter
and
midrange
independently
using
two
amplifiers.
When
using
the
components
in
the
Bi-Amp
configuration
you
are
going
to
need
two
stereo
amps
or
one
four
channel
amp
to
run
a
pair
of
components.
You
will
need
to
remove
the
Bi-amp
jumpers
from
the
input
connection
points
of
the
crossover.
Connect
the
desired
amp
or
channels
to
the
tweeter
input.
The
second
amplifier,
or
third
and
fourth
channels
of
the
4-channel
amplifier,
will
be
connected
to
the
woofer
input
on
the
crossover.
When
the
crossover
is
set
up
in
this
configuration,
the
final
load
will
be
4
ohms.
·
JUMPERS
II
EM
OilED
Note:
It
is
important
to
make
sure
the
gain
of
each
amplifier
is
matched.
Final
gain
level
adjustments
should
be
made
using
the
crossover
settings.