MTZ 952.2 - Tyres; Allowable combinations of front and rear tyres for the MTZ 920;920.2;920.3, MTZ 952;952.2;952.3 tractors

Operating Instructions
MTZ series 900
118
Tyres
IMPORTANT!
1 . Never exceed air pressure values recommended by the manufacturer for the tyres.
2 . Do not perform welding the disk or other repair works with the tyre inflated. To
unfit and repair the tyres, contact the workshop staffed with trained personnel.
Tyres used on the 900 series tractors
900/900.3/950/950.3
920/952
920.2/920.3/952.2/952.3
front
rear
front
rear
front
rear
Standard
9.00-20
9.00R20
18.4R34
(mod. Ф-11)
13.6-20
16.9R38
360/70R24
18.4R34
Optional:
7.50-20
18.4R30 or
18.4/78-30
15.5R38 18,4R34
(Ф-11)
16.9R38
9.5-42
11.2R42
11.2-20
15.5R38
18.4R34
18.4R30 or
18.4/78-30
(18.4L-30)
9.5-42
11.2R42
13,6-20
11.2R24
16.9R30
15.5R38
9.5-42
11.2R42
IMPORTANT! For tractors equipped with a FDA (920/920.2/920.3/952/952.2/952.3), the
properly selected combination of front and rear tyres should be used. Using proper front
and rear tyre combination will ensure maximum performance of the tractor, increase the
tyre service life and reduce the wear of the power transmission components. Simultane-
ous use of worn-out and new tyres, or tyres with different diameters or rolling radii can
lead to violation of the requirements concerning the kinematic non-conformance and ex -
cessive tyre wear. The table below gives recommended combinations of front and rear
tyres.
Allowable combinations of front and rear tyres for the MTZ
920/920.2/920.3, MTZ 952/952.2/952.3 tractors
Front tyres
920/952
920.2/920.3/952.2/952.3
Rear tyres
11.2-2 0
13,6-20
360/70R24
11.2R24
13,6-20
9.5-42
+
-
+
+
-
11.2R42
+
-
+
+
-
15.5R38
+
-
+
+
-
18.4R34 (Ф-11)
+
-
+
+
-
16.9R38
-
+
-
-
-
18.4R30 or 18.4/78-30 (18.4L-30)
+
-
-
-
-
16.9R30
-
-
-
-
+
To ensure the normal operation of the tractor, set the air pressure in the tyres according to the
table given below. The pressure must be set in cold tyres. When carrying out the works requiring
traction forces, set the pressure as for the speed of 30 km/h. When performing the transport works
on the roads with hard surfaces, increase the pressure by 30 MPa. When operating the front lift,
set the maximum pressure specified for the front tyres.