RMA hydraulic lift control
The hydraulic lift is controlled by means
of two levers (1, 2) located on the board
in the cab at operator’s right hand.
The power control arm (1) is located
close to operator and has the following
positions:
Rightmost: maximum tillage depth (digit
“9” on the board);
Rearmost: minimum tillage depth (digit
“1” on the board);
Full control range of the soil cultivation
depth: from “1” to “9”.
Position control lever (2) has the follow-
ing positions:
Foremost: minimal height of the imple-
ment above the soil surface (digit “9” on
the board);
Rearmost: transport position (digit “1” on
the board);
The maximum height of lifting the im-
plement by the position control lever is
provided by the adjustable stop (3).
NOTE: The combined control is provided
by limiting the tillage depth with the posi-
tion control lever in the mode of power
control by means of the lever (1).
IMPORTANT! If any of the distributor
control handle is set to the “Lift” or “Low -
ering” position, the hydraulic lift control
by means of the levers (1, 2) is automati-
cally ceased.
To Next Page
Loading...
