MUHLER Bobby 1 - Cotton Filter Maintenance; Maintenance of Charging Pins and Sensors

12
EN: ROBOT VACUUM CLEANER |
Instruction Manual
PARTS MAINTENANCE / COTTON FILTER
PARTS MAINTENANCE – CHARGING PINS, LOWER VISUAL SENSOR, DRIVING
WHEEL AND UNIVERSAL WHEEL
Note: the charging electrode, the lower visual sensor and the bumper contain sensitive
electronic components. Use a dry cloth to clean these parts. Do not use a wet cloth:
water may cause damage to them.
B. Take out the cotton filter from
outlet rubber plug.
C. Change a new cotton filter.
Cleaning the charging pins.
Cleaning the driving wheel and
the
universal wheel.
* If you will not use the vacuum cleaner for
a long time,
charge it fully
and shut it down
before you store it. Charge the robot every
three months in case of over
-
discharge of
the battery.
* If the
battery is over-
discharged or is not
used for a long time, the vacuum cleaner
may not be rechargeable. Contact the
after
-sales service for maintenance.
Do not disassemble the robot
!
Cleaning the lower visual sensor.
A. Take out the outlet rubber plug.
D. Install the outlet rubber plug.