Muji WORKING CHAIR User Manual

Parts List
WORKING CHAIR
JAN# 4548718121298
Assembly Instruction
①
②
for
Leg
Parts
Q’ty
for
Sea
for
Back
Lift up
③
When assembling,
use a rug to protect
floor from damage.
Remove Parts# 05~08 from back side of # 04.
Ope
Close
Lever
Handl
LoosenTighten
Long-Bolt
Long-Bolt
Top of Long-Bolt
Show
more
than
1mm
(0.04
Metal Base
Pipe of Metal Base
Botto
Top
Metal Base
Plate
Square
Square hole for
Long-Bolt
Long-Bolt
slide out
pull out
pull out
④
Remove Part# 11, and then Part#10 from
Pull to open the bottom part of
#11 in indicated direction by
hand.
Use string into pull out #11 if it is
Lift up the square bottom
part to attach to the plate
and make sure long-bolt is
fastened firmly.
Do not break Part# 11.
Keep reach of out of children.
Carefully handle sharp edges.
Open
⑤
Put together Parts# 09 and # 04.
⑥
⑧
⑦
Put Parts# 10 and # 11 back
Usage Instruction
1) Seat height adjustment
Please be seated and push the lever up to make the seat
higher.
2) Use handle to adjust the rocking of the seat back.
Do not too much
loosen the handle. It
may make the seat
back to come off
and cause injury.
When you loosen the handle
to adjust the seat back,
please remain at least 1mm
(0.04 inch) of top of
Long-Bolt to avoid the parts
coming off.
Put Parts# 05~08 back together.
Do not stand up
on chair or use
as stool.
Keep away from
fire.
Do not disassemble parts #02
(Gas Spring).
It may burst and cause injury.
Caution:
Caution:
Caution:
Caution:
Caution:

Muji WORKING CHAIR Specifications

General

Brand	Muji
Model	WORKING CHAIR
Category	Indoor Furnishing
Language	English

Summary

Parts List

Chair Base Assembly

Install Gas Spring

Install part #02 (Gas Spring) into the base assembly. Handle with care.

Caution: Gas Spring Safety

Do not disassemble the gas spring as it may burst and cause injury.

Seat and Back Assembly

Prepare Metal Base

Remove parts #05-08 from the back side of part #04 for assembly.

Attach Seat Plate

Lift up the square bottom part to attach to the plate and ensure long-bolt is fastened.

Connect Backrest

Assemble part #09 to part #04 (Plate) using long-bolts.

Secure Backrest Components

Attach parts #10 and #11 to the seat mechanism, ensuring proper connection.

Reassemble Seat Mechanism

Reassemble parts #05-08 together, ensuring correct order and fit.

Caution: Part #11 Handling

Do not break Part #11; keep away from children and handle sharp edges carefully.

Caution: Handle Adjustment

When adjusting seat back, leave at least 1mm (0.04 inch) of long-bolt.

Usage Instructions

Seat Height Adjustment

Push the lever up while seated to adjust the seat to a higher position.

Rocking Adjustment

Use the handle to adjust the rocking function of the seat back.

Safety Precautions

Do not stand on the chair, use as a stool, or expose to fire.