19
servicing your boom arm
Your Mullet Boom Arm is designed to make an endless amount of
memories. But there are a couple of components that can wear over time.
O RINGS
Worn O Rings can crack or compress over extended use compromising
easy rotation. Find replacements at mullettools.com.
TEFLON WASHERS*
Careful not to lose these little buggers when disassembling your Pivots,
as the Tee Knobs may not hold in place. But no sweat if you do – more can
be found at mullettools.com, along with virtually every other component.
Square O-Ring (#133) 2x
Molded Bushing
Carriage Bolt (1/4-20)
Teon Washer
Tee Knob
Clear, Polycarbonate Pivot 2x
Hard plumbed 1½” PVC ducting
*Note: Without Teon washer Tee Knob may tighten or loosen when rotating.
To Next Page
Loading...