132
www.multilaser.com.br
The WPS Configuration Screen of Wireless Adapter
II. By PIN
If the new device supports Wi-Fi Protected Setup and the PIN method, you can add it to the network by PIN with the following
two methods.
METHOD ONE: ENTER THE PIN INTO MY ROUTER
Step 1: Keep the default WPS Status as Enabled and click the Add device button in Figure 4 3, then the following
screen will appear.
Step 2: Choose “Enter the new device’s PIN” and enter the PIN code of the wireless adapter in the field after PIN
as shown in the figure above. Then click Connect.
Step 3: Por the configuration of the wireless adapter, please choose “Enter a PIN into my access point or a registrar”
in the configuration utility of the WPS as below, and click Next.
Note:
The PIN code of the adapter is always displayed on the WPS configuration screen.
To Next Page
Loading...