Multimac MINIMAC - Page 4

The Minimac locks into one
of the seat berths within the
Mulmac. (Check your seat
model as it does not t in all
seats, in certain models.
More info can be found on
the website on this.)
The locking mechanism is a lot
like a car door latch with two
clicks. The ‘tongue’ at the front
of the Minimac goes into the
slot at the back of the Frame
and then it locks down onto
the ‘striker pin’ in the seat well.
In the Superclub and Junior
models the plug in buckle
can stay in place while the
Minimac is ed but will
need to be removed in all
other models.
Remove the seat base (store
it somewhere safe as you will
need it once baby is ready to
go forward facing).
Tuck the harness out the way
so nothing is restricng the
Minimac locking into posion.
Hold the Minimac square to
the seat back – Geng the
right angle is important so the
tongue can slot into the hole.
Once you feel its in, push
the back part down onto the
lock with some force and you
should hear it click.
REMOVING THE MINIMAC
Find the lever at the back
of the seat and pull it to the
outside to release the lock,
whilst liing it out with the
carry handles.
2
PUTTING THE MINIMAC IN THE MULTIMAC
Lever
1368_Multimac_A5_Users Manual 2024_V5.indd 21368_Multimac_A5_Users Manual 2024_V5.indd 2 16/05/2024 15:2216/05/2024 15:22