MultiOne SRL
Self-moving Compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 6 Series
Instruction manual (Translation of the original instructions)
CM150032EN - 16.06.15 - 05 (11.07.18)
68/76
9.10 Troubleshooting
Problem Possible cause Solutions
Engine does not crank
The yellow switch on the joystick isn’t in the
neutral position
Set the yellow switch of the joystick in the
neutral position (center)
Battery switch off Turn on battery switch.
Discharged battery, low battery voltage Check and charge the battery.
Blown fuse Check fuses. If the fuse blows again, find out
the cause. Contact service.
Battery cables poorly connected or
disconnected.
Check battery cables and posts, clean and
retighten if necessary.
Engine cranks but does not start, or
starts and stops immediately
No fuel or wrong type of fuel Drain the tank then fill the tank with correct
type of fuel. Drain water from the fuel filter.
Prime the fuel system.
Engine does not get fuel, clogged fuel
filter or fuel line.
Drain water from the fuel filter. Prime the fuel
system.
Make sure that the fuel hoses and fuel filter
are clean and have not been frozen. Replace
fuel filter, clean fuel lines.
Cold temperature of the environment Hold ignition key in glow position for longer.
If glow indicator lamp is lit, allow it to turn off
before starting. Switch on the engine for at
least 5 seconds.
Battery discharged or damaged Charge the battery or replace if damaged.
Engine overheats
Clogged radiator Clean radiator and fan from engine side.
Coolant level low Add coolant.
Leaking cooling system. Check coolant pressure reservoir cap for
tightness. Check cooling system and all
hoses and connections.
Hydraulic system overheats
Clogged oil cooler. Clean cooler and fan.
Fan faulty Check and clean, repair if necessary.
Hydraulic system overloaded Use attachment at lower engine rpm, use with
1-pump setting, check attachment for faults.
The loader does not move even after the
parking brake has been released
Bad connection on the wiring of the parking
brake switch, blown fuse, or faulty switch.
Check wires, fuse, and switch, repair if
necessary. Contact service.
Low hydraulic charge pressure. Contact service for pressure check.
TAB. 24
9- MAINTENANCE