Need help?Do you have a question about the mundoclima MUPR-24-H11 and is the answer not in the manual?
General| Cooling Capacity | 24000 BTU/h |
|---|---|
| Heating Capacity | 24000 BTU/h |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (EER) | 3.21 |
| Coefficient of Performance (COP) | 3.61 |
| Refrigerant | R410A |
| Type | Split |
Guidelines and warnings for safe usage of the air conditioner to prevent hazards.
Essential safety guidelines for all electrical work and connections.
Critical safety instructions and precautions for installing the air conditioner unit.
Specific safety guidelines for operating the unit with R32 refrigerant.
Explains specific error codes displayed on the indoor unit and their meanings.
Continuation of the error code list, covering more display codes and their meanings.
Instructions for securely attaching the indoor unit's mounting plate to the wall.
Procedure for drilling the wall hole and installing the protective wall cuff.
Steps for preparing the refrigerant piping before passing it through the wall hole.
Instructions for connecting the drain hose for proper water drainage.
Essential safety regulations to follow before undertaking any electrical work.
Guidance on selecting and connecting the signal cable between units.
Crucial warning regarding correct wiring practices and avoiding mixed wires.
Criteria for selecting an appropriate location for the outdoor unit.
Steps for anchoring the unit and specifications for mounting dimensions.
Instructions for connecting signal and power cables to the outdoor unit.
Steps for correctly flaring pipe ends to achieve an airtight seal.
Procedure for connecting refrigerant pipes to indoor and outdoor units.
Step-by-step guide for performing the air evacuation using a vacuum pump.
Checks to confirm the unit's electrical system is safe and properly installed.
Methods for detecting refrigerant leaks using soap water or a detector.
Steps to follow during the test run to verify unit operation and safety.
Instructions to re-check pipe connections for leaks during the test run.
Methods for detecting leaks and procedures for refrigerant removal and evacuation.
Requirements and precautions for charging the refrigeration system.
To Next Page
