Murr Elektronik 55283 - Parameterization; Snmp

Manual for MVK-MPNIO Modules
58 V 1.9
4.3 Parameterization
T
his chapter explains the parameterization possibilities.
Parameters
Description
1
Signal / do not signal global diagnostics
Enables / disables all module diagnostics. If all diag-
nostics are disabled, the parameter settings 2 to 5 are
ignored.
2
Signal / do not signal channel diagnostics
Enables / disables all channel diagnostics
• Actuator short circuit
• Actuator warning
• Sensor short-circuit
•
Peripheral error
3
Signal / do not signal undervoltage of
bus/sensor supply
Enables / disables signaling undervoltage of
bus/sensor supply
4
Signal / do not signal undervoltage of
bus/sensor supply
Enables / disables signaling undervoltage of
bus/sensor supply
5
Signal / do not signal breakdown of actua-
tor supply
Enables / disables signaling no actuator supply
6
Function channel 00 .. 17
Selection between
• NO input
• NC input
• Diagnostic input (Channel 10..17)
• Output
4.4 SNMP
A
ll MVK MPNIO are able to send an SNMP message on request.
SNMPv2-MIB::sysDescr.0 Objekt (1.3.6.1.2.1.1.1.0).
C
ontent oft he SNMP message:
Murrelektronik, MVK ProfiNet, article no., HW-version, SW-version, MAC-adress.
or:
Murrelektronik, MVK-MPNIO, article no., HW-version, SW-version, MAC-adress.