Need help?Do you have a question about the Murrplastik MVPS G3 G and is the answer not in the manual?
Includes the engraving spindle with needle and the engraving head assembly.
Covers the counter bearing, securing device, and cover for the engraving head.
Details the various connecting cables (VEC) and the vacuum cleaner hose.
Includes calibration block, support arms, clamping piece, and mounting support for the engraving needle.
Details the Vacuum Engraver Controller (VEC) and the Vacuum Cleaner (VC).
Instructions for safely removing the plotter's penholder unit before attaching the engraving unit.
Steps to attach the holder and then the support arm to the plotter baseplate.
Procedure for securely fitting the engraving head assembly into the holder bearings.
How to use the red locking bar to ensure the engraving head remains stable during operation.
Guidance on initially loosely mounting and then firmly fastening the counter bearing for alignment.
Steps for precise alignment using a calibration block and counter bearing adjustment.
Advice on placing the VEC controller and vacuum cleaner near the plotter system.
Details on connecting the vacuum cleaner to the controller, plotter to controller, and power supply.
Instructions for connecting the vacuum hose and the spindle cable to the controller.
Method for adjusting the engraving depth using the spindle's depth regulator in 0.05 mm increments.
Guide to installing the correct printer driver from the ACS software CD, emphasizing specific device naming.
Specifies using plotter-defined calibration values and setting 90° rotation for MVPS G3-T.
Requirement for ACS software version 2.2.0.53 and its use in selecting material and speeds.
General| Category | Plotter |
|---|---|
| Manufacturer | Murrplastik |
| Model | MVPS G3 G |
| Material | Plastic |
| Application | Cable and hose protection |
| Bending Radius | 75 mm |
| Color | Black |
| Type | Drag chain |
To Next Page