Musical Paradise MP-301 MK2 User Manual (English)

MP-301 MK2 Quick Setup Guide

Revision: 1.3 Sep 12, 2011

Thanks for choosing Musical Paradise MP-301 MK2 integrated tube amplifier. Before

using this great sounding amplifier, please read the following setup guide carefully.

1. Place it on a flat place with good ventilation. Plug the tubes into the sockets

accordingly. V1 and V2 accept 6J8P, 6SJ7, 6SD7 and 5693 pre-amp tubes. V3 and

V4 accept 6L6, KT66, 5881, EL34, 6CA7 and KT77 power tubes.

2. Please hold the base of vacuum tubes when installing and removing them. Do

“NOT” push or pull the glass.

3. Do “Not” connect any headphones to the speaker output terminals directly. This

can cause permanent damage to the output transformers. Always use the

headphone jack at the front for connecting headphones.

4. Do “Not” turn on the amp without connecting either a headphone or speakers.

Users must connect their headphones and/or speakers to the amp all the time

when the amp is on, otherwise, the output transformers could be overheated

and damaged. If you don't use speakers with the amp, please make sure the

output selector is always on the headphone position, and a headphone is

connected.

Need help?

Do you have a question about the Musical Paradise MP-301 MK2 and is the answer not in the manual?

Musical Paradise MP-301 MK2 Specifications

General

Place the amplifier in a well-ventilated area and install pre-amp and power tubes into the correct sockets.

Hold vacuum tubes by their base when installing or removing to avoid damaging the glass.

Never connect headphones to speaker terminals; use the dedicated front headphone jack to prevent transformer damage.

Always connect headphones or speakers before turning on the amplifier to prevent transformer overheating and damage.