INTRODUCTION
When ordering service parts, specify the correct
part number, full description, quantity required, the
unit model number and serial number. For your
safety and continued proper operation, use only
genuine MUSTANG service parts.
The model and serial number for this unit are on a
tag located on a panel on the front of the cab.
“Right” and “left” are determined from a position
sitting on the operator’s seat and facing forward.
MUSTANG Manufacturing Company reserves the
right to make changes or improvements in the
design or construction of any part of the unit without
incurring the obligation to install such changes on
any previously delivered units.
Refer to the abbreviations table located on this page
for special parts descriptions. Standard attaching
hardware torque values are also provided near the
back of this manual. Metric torque values shown in
the illustrations are in Newton-meters and are
converted to foot-pounds by multiplying by 0.738.
Specific reference numbers, indicating a complete
assembly, are circled in some illustrations. A small
bag, pictured in some illustrations, indicates a seal
kit (seals, o-rings, etc.). In the exploded view parts
list, additional information may follow the
Reference Number.
Serial number breaks are indicated as follows:
• (SN 999 and before) - indicates serial numbers
up to and including 999.
• (SN 1000 - 2000) - indicates serial numbers
between 1000 and 2000.
• (SN 999 and up) - indicates serial numbers
including 999 and after.
Serial number exceptions and inclusion are
indicated as follows:
• (SN 999 and before except 997) - indicates
serial numbers up to and including 999,
EXCEPT 997.
• (SN 1000 - 2000 except 1996 including 997) -
indicates serial numbers between 1000 and
2000, INCLUDING 997 EXCEPT 1996.
• (SN 2001 and up including 1996) - indicates
serial numbers including 2001 and after,
INCLUDING 1996.
Unless otherwise specified, all cap screws and
bolts are Grade 8.8, cadmium or zinc plated.
NOTE:The following abbreviations may be
used herein:
ASSD............... Assembled
ASSY............... Assembly
AR ................... As Required
CB.................... Carriage Bolt
CP.................... Cotter Pin
CS.................... Cap Screw (Hexagon Head)
CYL................. Cylinder
DIA.................. Diameter
DIN.................. Deutsches Institut für Normung
FHCS............... Flat Head Cap Screw
GR ................... Grade
HB ................... Hex Bolt
HLN................. Hex Lock Nut
HN................... Hex Nut
HP.................... High Pressure
HYD ................ Hydraulic
INS .................. Insert
LH.................... Left Hand
LN.................... Lock Nut
LT .................... Left
LW................... Lock Washer
M ..................... Meter or Meters
MM/mm .......... Millimeter
NPT.................. National Pipe Threaded
NSS.................. Not Sold Separately
RH ................... Right Hand
RT.................... Right
SHCS............... Socket Head Cap Screw
SLTD ............... Slotted
SN.................... Serial Number or Slotted Nut
SQ.................... Square
W/.................... With
W/O................. Without
ZO.................... Zinc Oxide
ZY.................... Zinc Yellow
To Next Page
Loading...