VJ-1617H OPERATION MANUAL Before using
3-13
• If you have selected "Wash Exe? Yes" in step 4, the printer starts the cleaning operation
• "Wait for a while" is displayed on Operation panel.
• Maintenance starts.
• Print head moves to the left.
• Cleaning wiper rises.
• "CR Mainte.: End" is displayed on Operation panel.
6. Excecute the daily maintenance.
"
6.2 Daily maintenance"
or "User maintenance sheet" provided with the printer.
• If you have selected "Wash Exe? Yes" in step 4, you can skip the operation of dropping the
cleaning fluid on Cleaning wiper and Head cap unit with a dropper. Perform the rest of the
cleaning operation.
• Five minutes after "CR Mainte.: End" is displayed on Operation panel, the LCD
display changes to the following.
• When Right maintenance cover is open: "Close right mainte. Cover."
• When Left maintenance cover is open: "Close left mainte. Cover."
• If the above message is displayed, close Maintenance cover and stop the
operation. Perform Head cleaning, and then clean up again.
7. Press the [Enter] or [Cancel] key on Operation panel.
• "Wait for a while" is displayed on Operation panel.
• Cleaning wiper returns to the original position.
• Print head returns to its original position.
• "Power Off" is displayed on Operation panel.
• The printer turns the power OFF.
To Next Page
Loading...
Need help?
General