Safety Instructions 31
Concerning electric shock, short circuits and fire
Do not install the printer where it is humid or dusty.
It could lead to an electric shock and fire.
Make sure to use only the specified power supply.
If a power supply other than the specified voltage is used,
it could cause an electric shock and fire.
Do not use a damaged power cable.
It could lead to an electric shock and fire.
Take power for the printer directly from the power
socket.
Do not use multiple plugs on the same socket.
This could generate heat and might cause fire.
Do not pull out or insert the power plug with a wet
hand.
This could lead to an electric shock.
Be sure to use a dedicated power socket with earth
wire for the power supply, and connect it to the earth
wire.
If the earth wire is not connected, an electric shock or fire
may occur.
Do not connect an earth wire to the following places.
•Gas pipe
There is a possibility of ignition and explosion.
• Earth wire of telephone cables and lightning rods
Heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The earth might not work if a plastic pipe is connected
in the middle of the metal pipe.
Connect up the cords (cables) in the ways specified in
this Guide.
Mistakes in the cable connections could result in fire.
Do not insert or drop metal or flammable objects into
the printer through openings such as a vent.
It could lead to an electric shock or fire.
Be sure to use the specified power cord set.
• Using a power cord set other than the specified can
cause an electric shock or fire.
• Use a power cable that is equipped with a protective
grounding terminal, and connect it firmly to the outlet.
• Use a power cable that conforms to the safety
regulations, power supply voltage and plug shape of
the country where you are using it.
If foreign substances or liquids such as water entered
the printer, do not use the printer as it is.
It could lead to an electric shock or fire.
Turn the power button OFF immediately and disconnect
the power plug from outlet. Then contact the customer
support.
Do not place any combustible materials on the platen
while the heater is working.
There may be a risk of fire.
Leave ink cartridge from fire or objects with high
temperature.
It can cause fire.
Pay attention to the following points when
handling the power cord set.
• Do not tamper with the power cord set.
• Do not put heavy objects on the power cord set.
• Do not bend, twist or pull the power cord set by
force.
• Do not route the power cord set near heating
appliances.
Never open covers attached using screws under any
circumstances.
This may cause an electric shock or a malfunction.
Make sure to connect an earth wire to the earth
connection that meets the following standards.
• Earth terminal of power socket
An earth wire with a copper plate which is buried at
650 mm or more in the ground.
• Pay attention to the following points when
handling the power plug.
Any mishandling of the power cable could cause a fire.
• Make sure that no foreign substances such as dust
are stuck to the power plug.
• Make sure that the power plug is firmly inserted to
the edge of the power socket.
When you do not use the printer for a long
period, make sure to pull out the power plug
from the power socket for safety.
Make sure that no moisture enters the printer.
It could cause shorting of the electrical circuits.
WARNING
To Next Page
Loading...
Need help?
General