Choose a name that is as unique as possible
and enter the serial number and the device key
(without hyphens) of your device. Click on
Save.
If the cloud mode has been activated, an
overview of the operating data recorded from
then on is available after connecting the device
to the data platform.
Privacy
Information on the privacy regulations can be found at www.my-pv.com.
In order to simplify the analysis in the case of possible connection problems, a debug mode can be
activated in coordination with our technical support.
In the web interface the button leads to the online Operation Manual which corresponds to the
firmware version installed.
With this signal source, an electric heater in an AC off-grid system is linearly supplied with excess PV
power. The output of the AC•THOR is specified to the unit by a battery inverter through alteration of
the grid frequency via mains connection. Wiring for communication is not required!
As soon as the frequency control is selected as the signal source, the measured value is shown on
the display at the bottom right above the help button.
In boost backup mode, the battery must be expected to discharge!
TIP: Using several AC•THORs, each one may specify a different frequency range.
This means that prioritisation of several heat generators is possible even without
setting the multi-mode!
To Next Page
Loading...
Need help?
General