BROOKLYN BRIDGE
NETWORK QUICK SETUP GUIDE
The Brooklyn Bridge is a streaming device with D/A
and analog section inherited from our best selling
Mytek Brooklyn DAC+.
Follow these guidelines to enjoy your
favourite music collection.
Place the Brooklyn Bridge (aka BB) on at and open surface.
Now you need to decide what network connection you want to use: wired via Ethernet cable or Wi-Fi 2.4G.
CONNECTION
Connect Ethernet cable to the socket
or attach included Wi-Fi antenna
If you connected Ethernet
cable please wait until
ethernet icon will show up
Wi-Fi icon will appear on the
screen and show quality of
your wireless connection
Done - you are connected to network
via Ethernet cable!
Done - you are connected to Wi-Fi!
Optionally connect the BB outputs to your
system
Connect the BB to power outlet
– it will start automatically
1
1
5
6
4
4
11
12
13
7
7 7
7 7
8
5
8
13
9
9
11
10
2
2
1
3
3
The following steps only apply to a Wi-Fi connection
Find “Network” tile by turning a knob clockwise
Wait until “Network” tile is not greyed out
Push a knob to go to menu screen
Select connect tile on BB (4
th
button)
Wait up to one minute. You should see informa-
tion that the BB is connected to your network
Push a knob to exit to menu.
Select it via corresponding button
Turn a knob to select your local 2,4G Wi-Fi
Select connect tile on BB (4
th
button)
Enter your Wi-Fi password
• Turn knob to change character on selected position
• Use arrows (1
st
& 2
nd
buttons) to change cursor
position
To Next Page
Need help?
General
