N-Tron 7026 Series - Show or Set IGMP Configuration

For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
(Revised 2011-11-15) Page 142 of 169
CLI Commands, Continued…
Show or Set IGMP Configuration
Command Name
Igmp
Description
Show or set IGMP configuration. If no parameters are specified, this command will show
the IGMP configuration (same as -show parameter).
Syntax
igmp [-show] [-status state]
Parameters
-show
Show configuration.
-status state
Set the IGMP status to e(nabled) or d(isabled).
Examples
N-TRON/Admin> igmp –show
IGMP Status : Enabled
IGMP Version : 2
Query Mode : Auto
CIP Querier Status : 2, Active-Auto
Active Querier IP : 192.168.1.250
Router Mode : Auto
Manual Router Ports : (None)
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin> igmp –status disabled
IGMP Status : Disabled
IGMP Version : 2
Query Mode : Auto
CIP Querier Status : 2, Active-Auto
Active Querier IP : 192.168.1.250
Router Mode : Auto
Manual Router Ports : (None)
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin>…
NOTES