Nabtesco GM Series - Page 13

GM Series
TM19040 P.13/31
NOTE
At the time of delivery, covers or plugs are attached to ports of the product to prevent
contamination from entering inside. (They are not shown in the confirmation notice.) Do not
remove it during storage, and remove it when connecting pipes.
z Confirmation of lubricant
Refer to Replacement procedure (p. 23) in Sections 5.5 Replacing Lubricant. And check that the lubricant is
filled by using the oil level check port.
z Labeling
The nameplate is attached on the body of GM.
It indicates the product model, and others.
The model information includes the following product information.
＜Indication example of standard product model＞
ＧＭ ＶA－Ｋ－ ／ －
Design No.（Product class number）
Hydraulic motor displacement class
number (cm
3
/rev.)
Reduction ratio class symbol
Model symbol
Size No.
Representative model
＜Indication example of application product model＞
ＧＭY ＶA－B B－ － ／ －
Design No.（Product classification number）
Hydraulic motor displacement class
number（cm
3
/rev.）
Reduction ratio class symbol
Mechanical brake symbol
Accessory symbol
Model symbol
Size No.
Representative model
S/N
"シリアルNo."
MADE IN JAPAN
"品番"
”MSP番号”
”型式”
＜Nameplate example＞
“Model”
“MSP No.”
“Part number”
“Serial number”