GT10/GT30
GT30 Configuration Settings
110
6.2 Entering Configuration Settings from GTWIN Screen Creation Tool
6.2.2 GT Configuration Settings: “Basic Setup”
Selecting [Configuration] on the [File] menu of GTWIN and then the sub-menu [GT
Configuration] displays the “Basic Setup” screen shown below.
This is used to specify the basic communication area used for communication between
the GT30 and PLC, and the environment required for GT30 operation.
“Basic Setup” screen
Title - - - The title of the configuration settings file is entered here. Titlesare convenient
if each GT30 has its own configuration settings.
PLC Model - - - The model of PLC specified when GTWIN is booted is displayed here.
GT Model - - - The model of GT specified when GTWIN is booted is displayed here.
Basic communication area to PLC
The following explains how to specify a device in the PLC to be used for basic
communication between the GT30 and the PLC.
To Next Page
Loading...