GT30 Configuration Settings
GT10/GT30
121
6.2 Entering Configuration Settings from GTWIN Screen Creation Tool
Backlight control
Auto-Off
This is used to specify the Auto-Off backlight feature.
Off - - - The Auto-Off backlight feature is not used.
On - - - Auto-Off backlight feature is used. This parameter specifies the period of time
that the GT30 is inactive before the backlight goes off automatically.
If “On” is set for the aboveAuto-Off backlight feature, clicking onthe
buttondisplays
a screen where the time untilthe backlight goes off can bespecified. Any time fromone
minute to 30 minutes can be specified.
Key points
If the backlight is turned off automatically using the backlight control
function, touching the screen turns it on again. If a touch switch
happens to be located at that point on the screen, it will be invalid until
the backlight has gone on again.
Touch Sounds
This sets the touch sounds corresponding to GT30 screens as either invalid or valid.
Select one of the radio buttons.
Disable - - - Touch sounds are disabled.
Enable - - - Touch sounds are enabled.
Dead battery display
This specifies whether or not a dead battery mark will be displayed on the GT30 screen
if the voltage of the internal battery drops too low.
Don’t display - - - The dead battery mark is not displayed.
Display - - - The dead battery mark is displayed.
To Next Page
Loading...