GT10/GT30Preparation
186
1.1 Installing GTWIN
4. Enter the name of the file on which the function is to be run.
When “Run” is selected, the
dialog box shown at the left is
displayed. Enter:
e:\setup.exe
and click on the [OK] button.
Note: The drive in which the
CD is installed may be called
by a name other than “e”,
depending on the computer
configuration.
CAUTION
•
In order to use GTWIN, Windows 95 (OSR2 (Ver. 4.00.950B) or higher),
Windows 98, Windows Me, NT (Ver. 4.0 or a subsequent version) or
2000 must be installed in the computer.
•
The computer in which GTWIN is being installed must have at least 20
Mbyte of hard disk space available.
•
The above explanation assumes that Windows is installed in the C:
drive and that the CD drive is the E: drive. If your drives are
configured differently, or if you are installing the program over a
network, enter the appropriate drive name for your configuration.
5. A confirmation message is displayed.
When the setup program is
booted, a confirmation dialog
box is displayed. Confirm the
contents and click on the
[Next] button. To interrupt the
installation, click on
[Cancel].
To Next Page
Loading...