Setup
GT10/GT30
41
3.3 Setup Procedure for the GT30
When the menu operation as shown at the left page is carried out, the configuration file
is sent to the GT30. During the transfer, a screen like that shown below is displayed.
GTWIN
GT30
GT30 Configuration
file being transferred
Screen transfer cable
(AFC8503)
(4) Setup is completed.
If the transfer has been completed without any problems, the setup is completed.
CAUTION
Backup of the GT30 Configuration file
The GT30 Configuration file is stored in the user memory (F-ROM) of the
GT30. This file is deleted if the memory is initialized using the command
on the system menu of the GT30 main unit (see page 130), and will have
to be transferred again.
To Next Page
Loading...