Appendix A Device-Specific Information
M Series User Manual A-84 ni.com
SCC Accessories
SCC provides portable, modular signal conditioning to your DAQ system.
To connect your M Series device to an SCC module carrier, such as the
SC-2345, SC-2350, or SCC-68, use an SH68-68-EP shielded cable.
Refer to the SCC Advisor, available by going to
ni.com/info and
entering the info code
rdscav, for more information.
BNC Accessories
You can use the SH68-68-EP shielded cable, to connect your DAQ device
to BNC accessories, such as the following:
• BNC-2110—Provides BNC connectivity to all analog signals, some
digital signals, and spring terminals for other digital signals
• BNC-2111—Provides BNC connectivity to 16 single-ended analog
input signals, two analog output signals, five DIO/PFI signals, and the
external reference voltage for analog output
• BNC-2120—Similar to the BNC-2110, and also has a built-in function
generator, quadrature encoder, temperature reference, and
thermocouple connector
• BNC-2090A—Desktop/rack-mountable device with 22 BNCs for
connecting analog, digital, and timing signals
Screw Terminal Accessories
National Instruments offers several styles of screw terminal connector
blocks. Use an SH68-68-EP shielded cable to connect an M Series device
to a connector block, such as the following:
• CB-68LP and CB-68LPR unshielded connector blocks
• SCC-68 I/O connector block with screw terminals, general breadboard
area, bus terminals, and four expansion slots for SCC signal
conditioning modules
• SCB-68 shielded connector block with temperature sensor
• TBX-68 DIN rail-mountable connector block
To Next Page
Loading...
Need help?
General
