Note The device does not need an ID when connected via USB. The OLED
display returns ID not available when you connect the device via USB
only.
Tip Go to
Setting up the Host Computer to set up the soware
environment.
Tip Go to
Configuring the Device if you need to upgrade the soware on
the device or set up an administrator password.
Connecting to the Device via Ethernet
Complete the following steps to use an Ethernet cable to connect the NI ELVIS III to
your host computer.
1. Connect the Ethernet cable to the NI ELVIS III as shown in the following figure:
2.
Ensure that the Ethernet cable is connected to a router that is set up correctly.
ni.com
10
NI ELVIS III Getting Started
To Next Page
Loading...
