Electronic pellet burner controller - NPBC-V6T-2
13 Flue gasses alarm
Button
The exhaust temperature is extremely high and the
burner has stopped
14 Menu settings --- Date and time of the last access to the Settings menu
15 No Exec module --- No connection with the Executive module
16 Power On --- Date and time when the power supply to the
controller was turned on
17 Power Off --- Date and time when the power supply to the
controller was turned off
18 Reset --- Date and time when the controller's software or the
information in the Diagnostics screen has been reset.
If "◄" is pressed from the "Diagnostics" screen, go to the front "Information" screen. The same
can be done with a gesture – sliding on the right.
When the error messages appear in red color on the bottom of the main screen, they can be
cleared in following ways:
• automatically after the reason for the message is no longer present
• Pressing and holding the button for more than 2 seconds, while on the main screen if
the reason for the message is no longer present.
Automatic warning messages .
In some cases, screens with a red label "Warning!" and a message with the reason for appearing
may appear, for example as the screens below:
User Manual / ver. 1.2 http://www.naturela-bg.com/en/ page 23 of 41
To Next Page
Loading...
Need help?
General
