75
9. Reassembly is the reverse procedure. Secure the cables with zipties
(as noted in Step 2).
NOTICE:'RQRWFULPSWKHFDEOHV
10. If the Mast, Static Handlebar, Console and Top Shroud were
removed in Step 2, reinstall them. (Refer to the “Replace the Shrouds”
procedure.) Turn the power on.
Machine is on. Current is active. There is risk of electrical
shock.
11. Before fully attaching the Shrouds, use the console to set the
resistance to the highest level. Verify that the Brake Magnet and Flywheel
do not touch at the maximum resistance level. If necessary, refer to the
“Set the Brake Tension” procedure. Unplug the machine
Disconnect all power and allow to sit for 5 minutes.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
After replacing the MCB, the resistance levels of the machine may be
different. The user should adjust their workout levels accordingly.
To Next Page
Loading...
Need help?
General
