ENGINE ELECTRICAL 329
Figure 504 BCP, brake shutoff valve, and injecto
r locations
1. Injector connector (6)
2. BCP sensor connector (optional)
3. Brake shutoff valve connector
(optional)
4. Connect two ECM engine connectors.
5. Connect one IDM connector.
6. Connect one connector at EGR drive mod
ule.
7. Connect one, three wire ICP connector
to the
valve cover gasket.
8. Connect two additional, three wire co
nnectors for
the BCP sensor connector and brake sh
utoff valve
connector to the valve cover gask
et (optional).
9. Connect wiring harness at EGR dri
ve module.
10. Connect the ECM, IDM, and EGR drive
module
assembly ground.
11. Connect two ECM engine module con
nectors.
12. Connect three IDM Module connec
tors.
13. Connect the engine harness by co
nnecting the
harness at the various tie down
locations.
Figure 505 Connecting to the CKP sensor
14. Connect the wiring harness to th
e CKP sensor.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
