404 DIAMOND LOGIC® EN GINE BRAKE
Figure 650 Brake shutoff valve assembly
electrical connector
3. Connect brake shutoff valve electrical connector
to valve cover gasket pass-through connector and
clip harness to high-pressure oil rail.
Figure 651 BCP sensor electrical connector
4. Connect the BCP sensor electrical connector to
the valve cover gasket pass-through connector
(front) and clip harness to high-pressure oil rail.
5. Adjust brake actuator lash. See Brake Lash
Adjustment (Steps 2-6) in Periodic Service in this
“Diamond Logic® Engine Brake” section (page
392).
6. Install valve cover. See Valve Cover (Valve Cover,
page152) in the “Cylinder Head and Valve Train”
section of this manual.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
