80 INTAKE, INLET, AND EXHAUST M ANIF OLDS
Removal
GOVERNMENT REGULAT ION: Engine
fluids (oil, fuel, and coolant) may be a hazard
to human health and the environment.
Handle all fluids and other contaminated
materials (e.g. filters, rags) in accordance
with applicable regulations. Recycle
or dispose of engine fluids, filters, and
other contaminated m aterials according to
applicable regulations.
WARNING: To prevent personal injury or
death, read all safety instructions in the “Safe
ty
Information” section of this manual.
WARNING: To prevent personal injury or
death, shift transmission to park or neutral,
set
parking brake, and block w heels before doing
diagnostic or service procedures.
WARNING: To prevent personal injury or
death, allow engine to cool before working with
components.
WARNING: To prevent personal inj
ury or
death, wear safety glasses with
side shields.
Limit compressed air pressure t
o 207 kPa (30 psi).
WARNING: To prevent personal injury or
death, do not smoke and keep fuel away from
flames and sparks.
WARNING: To prevent personal injury or
death, do not let engine fluids stay on your skin.
Clean skin and nails using hand cleaner and wash
with soap and w ater. Wash or discard clothing
and rags contaminated with engine fluids.
NOTE: For information regarding the removal or
installation of adjacent components, refer to the
following service procedures located in other sections
of this manual:
•VGTturbo
•EGRvalve
•Fuelfilter assembly
• Crankcase breather
•Oilfill tube assembly
Exhaust Manifold
Figure 66 EBP tubing nut
1. EBP tubing nut
1. Disconnect the EBP tubing nut at exhaust
manifold.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
