Navistar INTERNATIONAL DT 570 - Engine Electrical 301

ENGINE ELECTRICAL 301
Table of Contents
Sensor Identification....................................................................................................303
Removal...................................................................................................................306
Sensor Wiring Harness ......................................................................................306
Injector Wiring Harness ......................................................................................312
ECM, IDM, EGR Drive Module, and Intake Air Heater....................................................313
Valve Cover Gasket with Pass-Through Connectors....................................................317
Cleaning and Inspection...............................................................................................319
Checking Wiring Harness and Electrical Connectors...................................................319
Installation................................................................................................................320
Valve Cover Gasket with Pass-Through Connectors....................................................320
ECM, IDM, EGR Drive Module, and Intake Air Heater ...................................................321
Injector Wiring Harness ......................................................................................327
Sensor Wiring Harness ......................................................................................328
Special Torque...........................................................................................................334
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.