6 PERFORMANCE DIAGNOSTICS 209
1. Connect the EZ-Tech® interface cable to the E ST
and the ATA connector.
2. Boot-up EST.
Figure 267 International® launchpad
3. Select Engine Diagnostics, then International®
MasterDiagnostics® II.
4. Turn the ignition s witc h to O N.
EGES-270-1
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
©August 2008 Navistar, Inc.
To Next Page
Loading...
