To Next PageTo Next Page
Need help?Do you have a question about the Navistar SmartDrive SR4 International LT 625 Series and is the answer not in the manual?
General| Brand | Navistar |
|---|---|
| Model | SmartDrive SR4 International LT 625 Series |
| Category | Automobile Accessories |
| Language | English |
Details preferred locations for cameras on flat windshields.
Details alternative locations for cameras on flat windshields.
Details preferred locations for cameras on split windshields.
Details alternative locations for cameras on split windshields.
Details primary and secondary wiring locations for the controller and ECU port.
Specifies part number, color, network, and baud rate for the 2016 DLC.
Details wiring connections for the controller, ECU port, and power sources.
Details the 9-PIN Type 2 Green Flange DLC, network, and baud rate.
Outlines wiring connections for the controller, ECU port, and power sources.
Describes the 2-Pin Delphi (purple inside) DLC, network, and baud rate.
Lists specific 360 Convoy VSAs that describe installation processes.
Details mounting location and installation steps for the ADAS forward-facing camera.
Provides mounting location and installation steps for the driver feedback device.
Addresses obstructions like sun visors and third-party devices affecting camera placement.
Covers installation steps and important notes for forward and cab-facing cameras.
Best practices for installing the cab-facing camera to avoid IR sensor obstruction.
Instructions on adjusting the forward-facing camera angle for optimal view.
Defines acceptable field of view for forward and cab-facing cameras.
Guidelines for installing sensor bars and keypads, including visibility and cable routing.
Covers service loops, zip ties, and connector handling for secure cable routing.
Differentiates between recommended permanent connections and disallowed quick-connectors.
Guides on using a multimeter to check constant power, true ignition, and ground.
Explains proper connections for MPC and LVD, emphasizing positive connections.
Identifies and describes the various ports on the controller for different components.
Details port assignments for forward/cab cameras, sensor bar, cellular, and WIFI antennas.
Describes port assignments for different analog cameras on the controller.
Explains how to interpret the Power, Ignition, and System LEDs for status.
Steps to prepare the vehicle and system for diagnostic mode and check connectivity.
Instructions on initiating and interpreting diagnostic mode fault codes.
Guide for performing self-checks using the mobile technician app.
Outlines the VSA process and how to manage installation exceptions.
Provides space for documenting and approving any exceptions to the installation specifications.
