Naztech Xpods PRO - Pairing and Power Management; Bluetooth Pairing Process; Power On and Off Methods

INSTRUCTIONS English
How to Pair
1. Remove the earbuds from the charging case. They will
turn on automatically and pair with each other.
2. Activate the Bluetooth feature on your device (phone,
tablet, etc.) and select “Naztech Xpods Pro” to connect
and pair.
NOTE: If your device prompts for a PIN code, enter “0000”
3. You will hear “Device Connected” conrming the
successful connection.
NOTE: The earbuds will automatically reconnect to the last
paired Bluetooth audio device when the unit is turned on.
Power On
Option 1: Remove the earbuds from the charging case. They
will turn on automatically.
Option 2: Touch the Control Zone on BOTH earbuds at the
same time for 5 seconds until you hear “Power On”
Power Off
Option 1: Place the earbuds in the charging case and close
the lid. They will turn off automatically.
Option 2: Touch the Control Zone on BOTH earbuds at the
same time for 5 seconds until you hear “Power Off”