NCR 2900/260 LF - Page 59

50
Continued
Action
Scan Code
Mode
Keyboard
Toggle Session Yes Ctrl-Enter (kpd)
Enter Desk Accessory
Mode
Yes
Ctrl-←
Enter Setup Mode Yes Ctrl-Scroll Lock
Exit Setup Mode Yes Pause
Enter Clock
11
Yes
Ctrl-←,F1
Enter Calendar
11
Yes
Ctrl-←,F2
Enter Calculator
11
Yes
Ctrl-←,F3
Enter ASCII Chart
11
Yes
Ctrl-←,F4
Enter Diagnostic
11
Yes
Ctrl-←,F5
Exit Any Desk Accessory Yes Esc
Next Page
12
No Ctrl-Page Down
Previous Page
12
No Ctrl-Page Up
Display Page 0
13
No Ctrl-0\Ins
Display Page 1
13
No Ctrl-1\End
Display Page 2
13
No
Ctrl-2\↓
Display Page 3
13
No Ctrl-3\Page Down
Notes:
1. This function is operational only if EIA (Aux) Rcv-Prtcl = Xon-Xoff/XPC or DTR
2. In ANSI emulations, this keystroke toggles in and out of Auto Print Mode.
3. This function is operational even if Screen - Saver is set to off.
4. The ACTION/Keystrokes shown for these Local Functions are programmed as defaults and can be changed
through the
“ALT key” parameter in setup mode.
5. This function unlocks the keyboard, turns off all print modes and re-initializes the serial ports for setup
parameters.
6. The length of the Break - Signal is dependent on the setup parameter of “EIA (Aux) Break”.
7. This keystroke is dependent on the “Disconnect” setting in the “Ke
ys” (F5) setup menu.
8. The Increment Scroll Rate toggles the scroll rate to the fastest smooth scroll. This function also stops at the
jump scroll. The
Decrement Scroll Rate toggles from jump scroll to the fastest smooth scroll toward the
slowest smooth scroll.
9. These functions are not available in ANSI emulations.
10. The Change Status Line function will toggle in the status line display from “Indicator” to “Host Write” to
“Both” to “Off” in ANSI Emulations and “Standard” to “Extended” to “Off” on ASCII Emulations.
11. Keystrokes for these functions are only operational if the “Desk Acc= Ctrl-←” in the
setup menu.
12. When a Split Screen is not enabled, these keys select the next or previous pages. Wrapping takes place from
the
last page to the first and vice versa.
13. These local functions are operational only if the selected page is available.
In Scan Code Mode (PC-Term emul.), this chart applies only when Local Leadin is on.