NCR 7167 - Page 137

7167 Owner’s Manual Chapter 6: Commands
November 2003
124
Reverse Feed n Lines
ASCII: GS DC4 n
Hexadecimal: 1D 14 n
Decimal:
29 20 n
Range of n : 0 – 127 7156 Emulation Mode
0 – 255 7158 Native Mode or 7167 Native Mode
Reverses the paper feed in the slip station by n lines at the current spacing. The next
character feed command returns the paper feed back to the normal feed direction. This
command is ignored if slip is not the selected station. Current spacing is not a factor.
Example:
MSComm1.Output = Chr$(&H1D) & Chr$(&H14) & Chr$(n)
Reverse Feed n Dots
ASCII: GS NAK n
Hexadecimal: 1D 15 n
Decimal:
29 21 n
Value of n:
n dots at 1/72 inch
Range of n : 0 – 127 7156 Emulation Mode
0 – 255 7158 Native Mode or 7167 Native Mode
Reverses the paper feed in the slip station by n dots at 1/72 inch (NCR 7150™ command).
This command is ignored if receipt station is selected.
Example:
MSComm1.Output = Chr$(&H1D) & Chr$(&H15) & Chr$(n)