NCR 7167 - Page 69

7167 Owner’s Manual Chapter 4: Diagnostics
November 2003
57
Configuration Menu and Print Test samples (show approximately 60% of size).
7167
A991703053
V00.17
C525
V03.12
0EFF
2Mbytes
256Kbytes
64Kbytes
64Kbytes
RS232/USB
9600
8
1
None
DTR/DSR
Print ‘?’
4K Bytes
OFF, Normal Mode
7158 Native Mode
7158 Native ID
7.52
To enter Diagnostics Mode:
1) Flip DIP switch #1 on
2) Reset the printer by pressing
and holding the Receipt Feed switch
down while disconnecting and
reconnecting the power.
*** Diagnostics Form ***
Model number
Serial number
Boot Firmware
Revision
CRC
Flash Firmware
Revision
CRC
Hardware
Flash Memory Size
Flash Logos Size
Flash Fonts Size
Flash User Storage
Communication Interface
Interface Type
Parameters
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Reception Errors
Receive Buffer
Diagnostic Mode
Emulation/Software
Printer Emulation
Printer ID Mode
Default LPI
*** Printer Config Menu ***
The config menu allows you to set
general printer parameters. Sub-menus
are entered and selections are made
using the Paper Feed Button:
- Short Click : Feed Button is
quickly depressed
then released.
- Long Click : Feed Button is held
Down more than 1sec
then released.
CAUTION !!
The settings are predetermined in
factory and should generally not be
changed to avoid changing other
functions.
**************
************* Main Menu *************
*****************************************
Select a sub –menu:
- EXIT 1 Click
- Print Current Configuration 2 Clicks
- Set Communication Interface 3 Clicks
- Set Diagnostics Modes 4 Clicks
- Set Emulation/Software 5 Clicks
- Set Hardware Options 6 Clicks
- Set Default Code Page 7 Clicks
Set EEPROM To Default 8 Clicks
Enter code, then hold Button DOWM
at least 1 second to validate
Important: Ensure that the
configuration settings match
your host computer, if not,
enter the Configuration Menu
to make changes.
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
: